When you start winding, whether beautiful or not, should pay attention to the following points:

Question: starting around the point too far or too far behind

Reason: there is no vertical phenomenon at the outlet.

Question: Cable too thin or too dense

Reason: foil type winding machine wire diameter is not correct.

Problem: the two ends of the rotary too fast or too slow

Reason: the width of the set is not correct: too fast because the width is not enough, too slow because the width is too large.

Question: cable follower whether more quickly or more slowly

Cause: then fine tune the size of the line: the faster = to change the smaller, the more slowly = to change.

Question: CNC winding machine winding deformation

Reason: it is a variant of the wound around a multi layer.

Problem: the wire diameter of the wire is the actual diameter of the wire,

Reason: set the line diameter must be added to paint package thickness will correct. The winding machine is completed, traverse return (low voltage foil winding machine displacement)

And it has a influence. Sparse winding, and around the best forward, the best width narrowed a bit.

Previous：How to carry over speed test to the automatic winding machine

Next：What are the components of the NC winding machine