The precise positioning of the automatic winder is very important when it stops. It will directly affect the accuracy of the winding. Most of the winding equipment manufacturers use the brake to control the spindle stop. With the increase of the use time and the number of times, there will inevitably be problems such as the deviation and abnormal noise of the stop position. The timely judgment and adjustment of the equipment can solve the problem of the positioning How to make the automatic winder locate accurately?

one. reasonable setting of parking parameters

The running process of the winding machine is from low speed to high speed to low speed. During normal processing and operation, the main shaft has certain load. High speed running and certain load make the equipment produce great mechanical impact. Before the main shaft stops, there must be a period of deceleration process. The higher the main shaft speed, the longer the deceleration process. Most of the equipment controllers are equipped with stop Vehicle deceleration function, the function of which is to set a deceleration process parameter from high speed to stop state of the equipment. The setting of this value should be increased correspondingly in high-speed operation or heavy load conditions, and the value should be set reasonably in combination with the actual winding process.

two. Regular inspection of brake

The brake in the winder belongs to the loss part. Its working performance decreases with the increase of service time, which will reduce the braking torque. The problems of the brake mainly focus on the following two aspects: 1. The performance of the brake coil is reduced; 2. The brake pad is worn. During the actual use, the brake pad wear is relatively common, which can be repaired by adjusting the brake clearance.

All the winding functions of CNC winder are configured according to the actual needs of winding. Only when the operator fully understands the working principle of the winder and masters certain maintenance and adjustment skills, can the winder reach its maximum efficiency.

Previous：Why the CNC winding machine to carry out the insulation resistance test

Next：What is the maintenance method of CNC winding machine